Analysis of Gas Turbine Performance based on Variation of Operating Load at PLTGU Panaran 1 Unit 1 PT.Mitra Energi Batam

Jhon Hericson Purba, Muhammad Syafei Gozali, Ferri Fernando Sitohang, Arif Febriansyah Juwito, Adlian Jefiza

Abstract


Gas and steam power generation units often experience changes in load according to the requested electricity needs. Changes in generator workload will also affect the efficiency of the generator. The different efficiency in each workload will have an effect on the amount of heat rate production produced when compared. By calculating the efficiency at each load, it will be useful to find out the workload with the best performance. From the results of the enthalpy calculation process based on the temperature of each gas turbine process, in this study the gas turbine performance is calculated, and then it compares the turbine performance with variations in operating load. The turbine performance that will be calculated includes compressor power, turbine power, net power, thermal efficiency, compressor efficiency, combustion chamber efficiency, turbine efficiency, heat input, and heat rate. The results of the calculation of the highest average thermal efficiency at 27 MW load were 35.18%; the average compressor efficiency experienced the highest increase at 25 MW load of 83.24%, followed by an average increase in combustion chamber efficiency and an average decrease in turbine efficiency at each increase in load, as well as experiencing the lowest decrease in heat rate at 27 MW load conditions of 2,842 kJ/kWh

Full Text:

PDF

References


I. Z. Putra et al., “Preliminary Study of the Vertical Axis Wind Turbine (VAWT) Prototype at Urban Area,” J. Integr., vol. 13, no. 1, hal. 6–9, 2021, doi: 10.30871/ji.v13i1.2754.

N. Gusnita dan K. S. Said, “Analisa Efisiensi dan Pemanfaatan Gas Buang Turbin Gas Alsthom Pada Pembangkit Listrik Tenaga Gas Kapasitas 20 Mw,” Sains, Teknol. dan Ind., vol. 14, no. 2, hal. 209–218, 2017.

J. H. Purba dan P. N. Batam, “Analisa Aplikasi Turbin Kobold Blade Kembar Sebagai Pembangkit,” no. November 2019, 2020.

T. Wang, Z. Yin, C. qing Tan, Y. sheng Tian, Q. Gao, dan H. liang Zhang, “High-power mode control for triaxial gas turbines with variable power turbine guide vanes,” Aerosp. Sci. Technol., vol. 86, hal. 132–142, 2019, doi: 10.1016/j.ast.2019.01.023.

L. B. Naryono, Ir., “Analisis Efisiensi Turbin Gas Terhadap Beban Operasi Pltgu Muara Tawar Blok 1,” Sintek, vol. 7, no. 2, hal. 78–94, 2013.

M. N. Annur, “Pengaruh Variasi Beban Terhadap Performa Turbin Gas Di PLTGU Blok Gt 1.3 Pt. Indonesia Power Grati,Pasuruan,” hal. 82, 2017, [Daring]. Tersedia pada: http://repository.its.ac.id/48179/.

M. Dubey, H. Chandra, dan A. Kumar, “Thermal modelling and optimisation of total useful energy rate of Joule–Brayton reheat cogeneration cycle,” Int. J. Sustain. Energy, vol. 35, no. 2, hal. 103–114, 2016, doi: 10.1080/14786451.2013.866952.

G. Shi, Z. Wu, T. He, D. Li, Y. Ding, dan S. Liu, “Shaft speed control of the gas turbine based on active disturbance rejection control,” IFAC-PapersOnLine, vol. 53, no. 2, hal. 12523–12529, 2020, doi: 10.1016/j.ifacol.2020.12.1795.

Riduwan dan Sunarto, Pengantar Statistika untuk Penelitian: Pendidikan, Sosial, Komunikasi, Ekonomi dan Bisnis. 2017.

J. Hosseinpour, M. Messele, dan A. Engeda, “Analysis and design of centrifugal compressor for 10 MWe supercritical CO2 Brayton cycles,” J. Mech. Sci. Technol., vol. 37, no. 5, hal. 2607–2621, 2023, doi: 10.1007/s12206-023-0435-4.

M. M. A. Al-Sood, K. K. Matrawy, dan Y. M. Abdel-Rahim, “Optimum parametric performance characterization of an irreversible gas turbine Brayton cycle,” Int. J. Energy Environ. Eng., vol. 4, no. 1, hal. 1–13, 2013, doi: 10.1186/2251-6832-4-37.

C. Dang, K. Cheng, J. Fan, Y. Wang, J. Qin, dan G. Liu, “Performance analysis of fuel vapor turbine and closed-Brayton-cycle combined power generation system for hypersonic vehicles,” Energy, vol. 266, hal. 126426, 2023, doi: https://doi.org/10.1016/j.energy.2022.126426.

H. S. Mann dan P. K. Singh, “Effect of number of blades in ducted turbine system on kinetic energy extraction from chimney flue gases - benchmarking with wind energy system,” J. Mech. Sci. Technol., vol. 32, 2018, doi: 10.1007/s12206-018-1042-7.

X. Ma, P. Jiang, dan Y. Zhu, “Performance analysis and dynamic optimization of integrated cooling and power generation system based on supercritical CO2 cycle for turbine-based combined cycle engine,” Appl. Therm. Eng., vol. 215, hal. 118867, 2022, doi: https://doi.org/10.1016/j.applthermaleng.2022.118867.

N. T. T. Truong et al., “Production of Medium Chain Fatty Acid Ethyl Ester, Combustion, and Its Gas emission using a Small-Scale Gas Turbine Jet Engine,” Int. J. Green Energy, vol. 16, no. 14, hal. 1304–1316, 2019, doi: 10.1080/15435075.2019.1671406.




DOI: http://dx.doi.org/10.24014/sitekin.v20i2.22786

Refbacks

  • There are currently no refbacks.


Copyright (c) 2023 SITEKIN: Jurnal Sains, Teknologi dan Industri



Editorial Address:
FAKULTAS SAINS DAN TEKNOLOGI
UIN SULTAN SYARIF KASIM RIAU
Kampus Raja Ali Haji
Gedung Fakultas Sains & Teknologi UIN Suska Riau
Jl.H.R.Soebrantas No.155 KM 18 Simpang Baru Panam, Pekanbaru 28293
Email: sitekin@uin-suska.ac.id
© 2023 SITEKIN, ISSN 2407-0939

SITEKIN Journal Indexing:

Google Scholar | Garuda | Moraref | IndexCopernicus | SINTA


Creative Commons License
SITEKIN by http://ejournal.uin-suska.ac.id/index.php