Ergonomic Analysis and Redesign of Bus Handgrips Using Rapid Upper Limb Assessment (RULA) and Posture Evaluation Index (PEI)
DOI:
https://doi.org/10.24014/jti.v12i1.39493Abstract
This study aims to analyze and improve the ergonomic performance of bus handgrips on Metro Jabar Trans using an integrated approach combining Rapid Upper Limb Assessment (RULA) and Posture Evaluation Index (PEI). The research employed a quantitative method involving 30 respondents, with data collected through observation, interviews, joint angle measurements, and anthropometric analysis. A virtual simulation was developed using Jack 8.4 software to evaluate ergonomic conditions based on RULA, Lower Back Analysis (LBA), and Ovako Working Posture Analysis System (OWAS), which were then integrated into the PEI metric. The results indicate that the existing handgrip design produces RULA scores predominantly at levels 5–6, reflecting moderate ergonomic risk, with PEI values ranging from 1.358 to 1.875, indicating suboptimal conditions. A redesigned handgrip was developed by optimizing key dimensions, including width, diameter, and finger clearance, based on anthropometric data. Simulation results demonstrate a consistent reduction in ergonomic risk, with PEI values decreasing to a range of 0.925 to 1.221. The reduction in PEI values, ranging from 0.233 to 0.903, confirms improved postural conditions and reduced risk of musculoskeletal disorders. These findings highlight that integrating posture assessment and quantitative ergonomic indices can effectively support the development of safer and more comfortable public transportation facilities.References
D. D. Putra, R. D. Aufaa, H. Luthfiyah, and S. Sahara, “Peningkatan Mutu Transportasi Umum Demi Kenyamanan dan Keamanan Pengguna,” Jurnal MIMBAR ADMINISTRASI, vol. 20, no. 1, 2023, doi: 10.56444/mia.v20i1.659.
S. N. Alivia, S. Yustika, and T. S. Nurjanah, “Identifikasi Transportasi Umum Bus di Kota Bandung Identification of Bus Public Transportation in Bandung,” JCIC: Journal of Urban Sociology, 2024.
P. dan P. K. B. Badan Perencanaan Pembangunan, “Kajian Perumusan Permasalahan dan Isu Strategis Kota Bandung Lingkup Sosial dan Pemerintahan,” 2023.
D. Pramesti, N. L. P. J. A. Andini, D. A. K. R. Raharjo, and A. D. Dwipayana, “Efektivitas Penggunaan Moda Transportasi Umum Dengan Kendaraan Pribadi,” Indonesian Journal of Multidisciplinary on Social and Technology, vol. 2, no. 1, pp. 6–16, Jan. 2024, doi: 10.31004/ijmst.v2i1.246.
F. S. Pahlevi, “Eksistensi Perum DAMRI Dalam Upaya Menjaga Stabilitas Ekonomi Nasional,” Journal of Islamic Economics and Finance, vol. 2, p. 43, 2022, doi: doi.org/10.37680/ijief.v2i1.1590.
F. Afandi, E. Khairina, and T. Dompak, “Strategi Optimalisasi Pemerinrah Indonesia Dalam Meningkatkan Kualitas Pelayanan Transportasi Umum,” Jurnal Progress Administrasi Publik (JPAP), vol. 5, no. 1, pp. 39–45, 2025, doi: 10.37090/jpap.v5i1.2153.
R. Situru, J. Tandirerung, and K. Sambara, “Pengaruh Pelatihan Terhadap Peningkatan Kinerja Karyawan Pada Perum DAMRI Makassar,” YUME : Journal of Management, vol. 8, no. 1, pp. 1749–1758, 2025.
A. Kabir, F. Kabir, S. N. Chowdhury, S. A. Urmee, and A. R. M. H. Rashid, “Literature Review and Primary Design on Ergonomic Handgrip for Public Transportation,” in Proceedings of the 5th International Conference on Industrial & Mechanical Engineering and Operations, Bangladesh, 2022, pp. 570–578. doi: 10.46254/BD05.20220162.
H. L. Lee, S. K. An, J. Y. Lee, D. W. Shim, B. R. Lee, and G. Y. Yang, “An Experimental Study on the Relationship Between Temperature and Pressure Inside the Cup During Cupping Procedures,” Journal of Acupuncture Research, vol. 38, no. 1, pp. 41–46, Feb. 2021, doi: 10.13045/jar.2020.00346.
A. A. Wardani and D. Andarini, “Analisis Ergonomis Stasiun Kerja Pekerja Pemanggang Kemplang Dengan Metode Posture Evaluation Index Dalam Virtual Environment,” PREPOTIF : Jurnal Kesehatan Masyarakat, vol. 8, no. 1, pp. 715–721, 2024.
D. Pardo Ramos, A. Muller, R. Dumas, and A. Savescu, “Evaluation of lower back and lower limb kinetics while lifting a baby dummy in squatting, kneeling and standing postures,” Int. J. Ind. Ergon., 2026, doi: 10.1016/j.ergon.2026.103920.
M. Iqbal, “Re-design Alat Bantu Pada Pekerja di Departemen Loading Ramp Guna Meningkatkan Produktivitas Pekerja di PT. Socfindo Kebun Sei. Liput,” Universitas Malikussaleh Lhokseumawe, 2023. doi: 10.31004/prepotif.v8i1.26819.
JannahMitahul and Linda Suwarni, “Analisis Determinan Ergonomi dan Karakteristik Individu terhadap Keluhan Musculoskeletal Disorders (MSDs) pada Tenaga Kerja Bongkar Muat Pelabuhan,” Sehat Rakyat: Jurnal Kesehatan Masyarakat, vol. 5, no. 1, pp. 24–35, Feb. 2026, doi: 10.54259/sehatrakyat.v5i1.5584.
Rifano and Kansayulisa, “Ergonomic Analysis of Handgrips on Suroboyo Bus Using The Rapid Upper Limb Assessment (RULA) Method,” in BIS Energy and Engineering, Universitas Muhammadiyah Magelang, May 2024, p. V225050. doi: 10.31603/biseeng.342.
S. Sundana and S. B. W. Utomo, “Analisis Tingkat Risiko Ergonomi Pada Product Support Pembuatan Pallet Menggunakan Metode Rapid Upper Limb Assessment Di PT XYZ Analysis Of Ergonomic,” Jurnal Baut dan Manufaktur, vol. 06, no. 2, pp. 2964–4461, 2024, doi: 10.34005/bautdanmanufaktur.v6i1.4042.
K. T. Khasianto, A. B. Purwantoro, and H. Wibowo, “Analisis Ergonomi Kursi Pengemudi Bus Menggunakan Metode Posture Evaluation Index (PEI) Berbasis Virtual Environment Modelling,” Journal Of Industrial Engineering And Technology (Jointech) Universitas Muria Kudus Journal homepage, vol. 5, no. 1, pp. 86–97, 2024, [Online]. Available: http://journal.UMK.ac.id/index.php/jointech
D. A. Lawolo and A. Febrianti, “Evaluasi Sistem Kerja Pengangkatan Gabah Padi untuk Mengurangi Gejala Musculoskeletal Disorders yang dialami Kuli Angkut Menggunakan Metode Posture Evaluation Index (PEI),” in Proceeding FTI, 2024.
M. Irfan Syahroni, “Prosedur Penelitian Kuantitatif,” Jurnal Al-Musthafa STIT Al-Aziziyah Lombok Barat, vol. 2, no. 3, 2022.
R. Susanti, “Sampling Dalam Penelitian Pendidikan,” TEKNODIK, 2005, [Online]. Available: http://www.pustekkom.go.id
M. Ahmad and S. Wilkins, “Purposive Sampling In Qualitative Research: a Framework for The Entire Journey,” Qual Quant, no. 59, pp. 1461–1479, 2025, doi: 10.1007/s11135-024-02022-5.
B. Arianto, Triangulasi dalam Penelitian Kualitatif. Balikpapan: Borneo Novelty Publishing, 2024.
W. Vera Nurfajriani et al., “Triangulasi Data Dalam Analisis Data Kualitatif,” Jurnal Ilmiah Wahana Pendidikan, vol. 10, no. 17, pp. 826–833, 2024, doi: 10.5281/zenodo.13929272.
D. Widya Yasmin, F. Saftarina, T. A. Happy, and R. Himayani, “Systematic Review: Penilaian Postur Kerja Menggunakan Rapid Upper Limb Assessment (RULA) Pada Petani Dengan Keluhan Musculoskeletal Disorders (MSds)”, doi: 10.37287/jppp.v7i3.6584.
T. Harto, R. Ferdi, and M. A. Akbar, “Prevalence of Low Back Pain and Associated Risk Factors among Nursing and Midwifery Students in Indonesia: A Cross-Sectional Study,” Journal of Health and Nutrition Research, vol. 4, no. 2, pp. 696–705, Aug. 2025, doi: 10.56303/jhnresearch.v4i2.454.
G. O. Forkuo, E. Bilici, and S. A. Borz, “Automated OWAS in Forestry Using Deep Learning for Posture Classification,” Int. J. Ind. Ergon., vol. 113, May 2026, doi: 10.1016/j.ergon.2026.103930.
S. Debora and A. Suryadi, “Analysis of Cleaning Service Work Postures to Reduce Musculoskeletal Injuries with the Posture Evaluation Index Approach,” Journal La Multiapp, vol. 6, no. 1, pp. 12–22, Jan. 2025, doi: 10.37899/journallamultiapp.v6i1.1785.
Downloads
Published
Issue
Section
License
Authors who publish with Jurnal Teknik Industri: Jurnal Hasil Penelitian dan Karya Ilmiah dalam Bidang Teknik Industri agree to the following terms:
1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License (CC BY-NC-SA 4.0) that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).